Node Maintenance Guide
This section describes how to handle planned maintenance of nodes.
Cordon the node. Longhorn will automatically disable the node scheduling when a Kubernetes node is cordoned.
Drain the node to move the workload to somewhere else.
You will need to use
--ignore-daemonsets options to drain the node because Longhorn deployed some daemonsets such as
Longhorn CSI plugin,
The replica processes on the node will be stopped at this stage. Replicas on
the node will be shown as
Note: By default, if there is one last healthy replica for a volume on the node, Longhorn will prevent the node from completing the drain operation, to protect the last replica and prevent the disruption of the workload. You can either override the behavior in the setting, or evict the replica to other nodes before draining.
The engine processes on the node will be migrated with the Pod to other nodes.
Note: If there are volumes not created by Kubernetes on the node, Longhorn will prevent the node from completing the drain operation, to prevent the potential workload disruption.
drain is completed, there should be no engine or replica process running on the node. Two instance managers will still be running on the node, but they’re stateless and won’t cause interruption to the existing workload.
Note: Normally you don't need to evict the replicas before the drain operation, as long as you have healthy replicas on other nodes. The replicas can be reused later, once the node back online and uncordoned.
Perform the necessary maintenance, including shutting down or rebooting the node.
Uncordon the node. Longhorn will automatically re-enable the node scheduling.
If there are existing replicas on the node, Longhorn might use those
replicas to speed up the rebuilding process. You can set the
Replica Replenishment Wait Interval setting to customize how long Longhorn should
wait for potentially reusable replica to be available.
Follow the official Kubernetes upgrade documentation.
To remove a disk:
These steps also apply if you’ve replaced a node using the same node name. Longhorn will recognize that the disks are different once the new node is up. You will need to remove the original disks first and add them back for the new node if it uses the same name as the previous node.
To remove a node:
Disable the disk scheduling.
Evict all the replicas on the node.
Detach all the volumes on the node.
If the node has been drained, all the workloads should be migrated to another node already.
If there are any other volumes remaining attached, detach them before continuing.
Remove the node from Longhorn using the
Delete in the
Or, remove the node from Kubernetes, using:
kubectl delete node <node-name>
Longhorn will automatically remove the node from the cluster.
© 2019-2023 Longhorn Authors | Documentation Distributed under CC-BY-4.0
© 2023 The Linux Foundation. All rights reserved. The Linux Foundation has registered trademarks and uses trademarks. For a list of trademarks of The Linux Foundation, please see our Trademark Usage page.